
Bring the surface variation into the lighting discussion. A sample that is easy to photograph may not represent the finish, colour or geometry that the inspection station will see during ordinary production.
Show the feature that needs to stand out
Identify the area and the decision to be made, then provide the agreed examples. Keyence’s lighting-selection guide illustrates how lighting arrangements influence the visibility of surface features. It is background guidance, not a validation of a specific Astra configuration.
Review the normal range of finishes
Use the variation approved for the part, including examples that have caused inspection difficulty. Ask the supplier to explain what changes between images and what remains controlled. Avoid treating an adjusted display image as proof of a complete production method.
Keep the demonstration repeatable
Record the relevant setup with the trial results and note changes made between runs. The responsible application team should decide how environmental variation will be assessed. Do not prescribe a universal lighting arrangement before the part has been evaluated.
Turn observations into questions
If a feature disappears under a changed condition, document it and ask how the proposed system addresses that condition. Our automotive AOI equipment guide places image review alongside coverage and operation.
Frequently asked questions
Should a lighting trial use only the easiest part to photograph?
Use representative finishes and relevant difficult examples so the trial addresses the intended production variation.
Is one lighting arrangement best for every automotive component?
No universal choice should be assumed. Review the surface, geometry and inspection objective with the application team.
What should be recorded when lighting is adjusted during a trial?
Identify the changed setup and the results obtained under it so comparisons remain meaningful.