
Draw the inspected areas onto a part reference before reviewing camera views. This makes it easier to ask whether each feature is visible, whether the fixture obscures it and what evidence the proposed view will provide.
Distinguish coverage from useful detail
NI’s image-acquisition guidance discusses field of view and image-resolution considerations. Seeing the entire part in one image does not, by itself, establish that a small feature can be evaluated to your requirement. Ask for an application-specific explanation.
Check the part in its proposed position
Review the actual orientation and fixture rather than an unsupported part held by hand. Include the faces that matter and identify concealed areas. Ask what additional view or handling would be required if an important feature is not accessible.
Keep the result tied to the task
A cosmetic inspection image and a dimensional result answer different questions. Ask the supplier to show how the evidence supports the defined decision, without assuming that magnification alone establishes measurement capability.
Record the coverage boundaries
Keep the marked-up part reference with the trial scope. The component inspection equipment selection guide connects these view checks to the configuration comparison.
Frequently asked questions
Does a full-part image prove small defects can be assessed?
No. Ask whether the relevant feature is resolved under the proposed imaging conditions and demonstrate the required decision.
Why review views with the fixture in place?
The fixture and part orientation can affect which areas are accessible, so the proposed operating arrangement should be included.
Can higher magnification alone prove dimensional accuracy?
No. Review the complete measurement method and evidence against the actual requirement.